R&S SMW-K555, User Manual, Page: 22 / 45

Extending the bandwidth
R&S
®
SMW-K555
22 User Manual 1179.5776.02 ─ 01
9. Wait until the alignment procedure finishes. Setup alignment can take several
minutes.
If the alignment finishes, the wizard closes and the setup info button displays no
conflict anymore.
After setup alignment check, if the RF ports configuration is correct, see "To moni-
tor the RF ports settings of a single R&S SMW" on page 22.
Continue with aligning the RF ports. You have two options:
●
"To align RF ports with a power sensor" on page 23
● "To align RF ports with a signal analyzer" on page 24
To monitor the RF ports settings of a single R&S SMW
1. Edit a bandwidth extension setup file.
See steps (1) and (3) in "To manage bandwidth extension setup files" on page 19.
The "RF Ports" tab of the dialog "Bandwidth Extension Setup File Editor" opens.
2. Check the settings for a single R&S SMW:
● Number of RF ports = 2
The setting is fixed for a single R&S SMW.
● Resulting bandwidth: 4.0 GHz
The value depends on installed bandwidth options, see Chapter 2.1, "Required
options" , on page 9.
● Maximum center frequency: 43.00 GHz
The value depends on installed frequency options, see Chapter 2.1, "Required
options" , on page 9.
● RF sources for two ports: R&S SMW path A and path B
"this" indicates the configuration of your R&S SMW.
● Hostname/IP address of the R&S SMW
● Maximum frequency: 44.0 GHz
The value depends on installed frequency options, see Chapter 2.1, "Required
options" , on page 9.
● Remote status: (connected), (connection error)
Configuring the R&S SMW