R&S FSV-K8, Operating Manual

Page: 92 / 135

Remote Commands for Bluetooth Measurements (K8)
R&S
®
FSV-K8
92 Operating Manual 1176.7610.02 ─ 02
Parameters:
<NoChannels> 1 to 78
*RST: 78
Example: CONF:BTO:ACLR:ACP 10
Selects 10 adjacent channel pairs.
Mode: BT
Manual operation: See "No. of ACP Chan (TX Spec ACLR, Spurious Emissions)"
on page 41
CONFigure:BTOoth:BANDwidth|BWIDth[:RESolution] <Bandwidth>
This command sets the resolution bandwidth of the analyzer for the currently selected
Bluetooth measurement (see
[SENSe:
​
]BANDwidth|BWIDth[:
​
RESolution]
​
on page 113).
For the measurements of modulation characteristics, initial carrier frequency tolerance,
and carrier frequency drift (see
CONFigure:
​
BTOoth:
​
MEASurement
​
on page 96),
the resolution bandwidth corresponds to the IF bandwidth of the signal. If the resolution
bandwidth is changed, its coupling to the settings according to the RF Test Specifica-
tion is cancelled.
Note:
The settings for the measurements are valid for all three measurements.For all other
Bluetooth measurements the setting is only valid for the currently active measurement
(see
CONFigure:
​
BTOoth:
​
MEASurement
​
on page 96).This command is not availa-
ble with active Adjacent Channel Power measurement.
Parameters:
<Bandwidth> 300kHz to 10MHz
*RST: AUTO is set to ON
Example: INST:SEL BTO
Activates the Bluetooth Measurements option.
CONF:BTO:MEAS OPOW
Activates the Output Power measurement.
CONF:BTO:BAND 1KHZ
Sets the resolution bandwidth to 1kHz.
Mode: BT
Manual operation: See "Res BW Manual (Output Power, Rel TX Power)"
on page 54
CONFigure:BTOoth:BANDwidth|BWIDth[:RESolution]:AUTO <Mode>
This command couples the resolution bandwidth to the settings according to the RF
Test Specification.
Note:
CONFigure:BTOoth Subsystem (BLUETOOTH, K8)