Loco-1 / Loco-2
V1.1 - English
page 18 of 36
Example:
If you want to program the value of 197 (bit value 11000101) into the
register 90, proceed as follows:
-
Program a 3 into the register 8 to set the two most significant
bits (binary = 11 decimal 3)
-
Program a '1' into the register 9 to switch the register bank
-
Program a 5 (decimal 5 = binary 000101) into the register 11 (=
90 - 79)
Do not forget before programming the next register, to set the two
most significant bits in register 8 accordingly. The reset of the register
bank is done automatically after writing a register (with index > 79).
The programming mode is terminated by switching off the digital
voltage. To do so press the "Stop" button on the control central.
Note: With Märklin® Central the value '0 'needs to be entered as
‘80'.
Tip: If you use a multi-protocol center, we recommend that you at
least perform the programming in DCC mode. The settings are inde-
pendent of the programming method used.
