Loco-1 / Loco-2
V1.1 - English
page 12 of 36
Acceleration and braking delay
The acceleration and braking delay can be individually programmed.
Emergency stop
With a change of direction while driving an emergency stop is exe-
cuted automatically.
Speed
characteristic
By setting the start, mid and top speed the decoder can be adjusted
to the driving characteristics of the engine and the characteristic
speeds of the locomotive type. The decoder generates a linear velo-
city curve from the start, mid and top speed.
If the speed mode is set to 28 speed steps, any motor voltage can be
assigned to an alternative to the linear velocity characteristic of each
of the 28 speed steps. This allows the creation of a form adapted to
the individual driving characteristics of the engine speed character-
ristic. The set values are stored in the alternate speed table.
Shunting speed
With appropriate programming the loco can be switched via a
function key to the shunting speed. In the shunting speed all speed
levels are reduced by approximately 50% compared to the set speed.
Note: In speed step 1, the driving speed is not reduced further.
Braking section
The decoder supports the Märklin® braking section. The mode can
be adjusted via the corresponding CV.
Only Loco-1:
In addition the decoder supports the simple ABC-(DCC)
braking section. Both types can be combined.
