RAMMER 1533E, Operator'S Manual

Page: 68 / 74

COPYRIGHT © 2020 SANDVIK MINING AND CONSTRUCTION OY Page 68 - Specifications
Hammer specifications 1533E STD
1.3 MOUNTING BRACKET SPECIFICATIONS
Item Specification
Bottom plate, recommended minimum
thickness (X) 25 mm (0.98 in)
Side plate, recommended minimum
thickness (Y) 25 mm (0.98 in)
Note: After welding, check the flatness of the plate and mill surface as needed.
The maximum acceptable deviation from flatness is 1 mm (0.04 in).
Consider the following when designing mounting brackets
Required plate thicknesses.
Correct transport position of the hammer.
Most common hammering position, in which the bucket cylinder is in the middle
position.
Mechanical stops to protect the bucket cylinder when the hammer is fully in or
out
Placement of the pin holes on the mounting bracket hinges. Normally, they are
placed almost symmetrically from the hammer center line.
Height of the stick's mounting bracket pin from the mounting bracket bottom
plate (A). The height depends on how close the pin is to the hammer center line.
The closer it is, the longer dimension (A) must be.
Effect of hammer recoil and feed force on the bucket cylinder, which should be
minimized. This effect depends on distance (B). The longer distance (B) is, the
smaller the effect.
R040238
X Y
B
A