RAMMER 1533E, Operator'S Manual

Page: 6 / 74

COPYRIGHT © 2020 SANDVIK MINING AND CONSTRUCTION OY Page 6 - Operation
Foreword 1533E STD
1.2 IMPORTANT SAFETY INFORMATION
Basic safety precautions are outlined in the "Safety" section of this manual and in
the description of operations where hazards exist. Warning labels have also been put
on the machine to provide instructions and to identify specific hazards which if not
observed could cause bodily injury or death to you or other persons. These warnings
in the guide and on the machine labels are identified by the warning symbol.
To use the attachment correctly, you must also be a competent operator of the carrier
machine. Do not use or install it if you cannot use the carrier machine properly. The
attachment is a powerful tool. If used without proper care, it can cause damage.
Do not rush when you are learning to use the product. Take your time and most
importantly, take it safely. Do not guess. If there is anything you do not understand,
ask your local dealer.
Improper operation, lubrication or maintenance of this machine can be dangerous
and could result in injury.
Do not operate this machine until you have read and understood the instructions in
this manual.
Do not perform any lubrication and maintenance on this machine until you have
read and understood the instructions in this manual.
1.3 WARRANTY
Check that a separate warranty sheet explaining the export warranty terms is
delivered with the attachment. If not, contact your local dealer immediately.
WARRANTY REGISTRATION CARD
A warranty registration card is filled out after the installation inspection by the
dealer and a copy of it is sent to the manufacturer. This card is very important
because no warranty claims are handled without it. Make sure that you get a copy
of it after the installation inspection and that it is correctly filled out.
INSTALLATION INSPECTION
An installation inspection must be carried out after the product has been installed on
the carrier. In the installation inspection certain specifications (such as operating
pressure and oil flow) are checked so that they are within given limits. See
“Hammer specifications” on page 66.