RAM 1500 2019, User Manual

Page: 57 / 340

tures. Call toll-free 1-800-355-3515 or, on
the Internet at HomeLink.com for safety in-
formation or assistance.
Before You Begin Programming
HomeLink
Ensure your vehicle is parked outside of the
garage before you begin programming.
For efficient programming and accurate
transmission of the radio-frequency signal it
is recommended that a new battery be placed
in the hand-held transmitter of the device
that is being programmed to the HomeLink
system.
To erase the channels place the ignition in
the ON/RUN position and push and hold the
two outside HomeLink buttons (I and III) for
up to 20 seconds. The instrument cluster
display will display “CLEARING CHAN-
NELS.” Release the buttons when “CHAN-
NELS CLEARED” appears on the display.
NOTE:
• For vehicle’s equipped with Keyless Enter-
N-Go, place the ignition in the RUN posi-
tion with the Engine ON. Make sure while
programming HomeLink with the engine
ON that your vehicle is outside of your
garage, or that the garage door remains
open at all times.
• Erasing all channels should only be per-
formed when programming HomeLink for
the first time. Do not erase channels when
programming additional buttons.
• If you have any problems, or require assis-
tance, please call toll-free1-800-355-3515
or, on the Internet at HomeLink.com for
information or assistance.
Programming A Rolling Code
For programming garage door openers that
were manufactured after 1995. These garage
door openers can be identified by the
“LEARN” or “TRAIN” button located where
the hanging antenna is attached to the garage
door opener. It is NOT the button that is
normally used to open and close the door. The
name and color of the button may vary by
manufacturer.
1. Turn the ignition switch to the ON/RUN
position.
NOTE:
For vehicles equipped with Keyless Enter-
N-Go, place the ignition in the RUN posi-
tion with the Engine ON. Make sure while
programming HomeLink with the engine
ON that your vehicle is outside of your
garage, or that the garage door remains
open at all times.
2. Place the hand-held transmitter 1 to
3 inches (3 to 8 cm) away from the
HomeLink button you wish to program.
3. Push and hold the HomeLink button you
want to program while you push and hold
the hand-held transmitter button.
4. Continue to hold both buttons until the
instrument cluster display changes from
“CHANNEL # TRAINING” to “CHANNEL
# TRAINED,” then release both buttons.
NOTE:
• It may take up to 30 seconds or longer
in some cases for the channel to train.
• If “DID NOT TRAIN” appears in the
Instrument Cluster Display, repeat from
Step 2.
55