RAM 1500 2019, User Manual

Page: 181 / 340

• When the LaneSense system senses the
lane has been approached and is in a lane
departure situation, the left lane line
flashes yellow (on/off). The LaneSense tell-
tale
changes from solid yellow to flash-
ing yellow. At this time torque is applied to
the steering wheel in the opposite direction
of the lane boundary.
For example: If approaching the left side of
the lane the steering wheel will turn to the
right.
NOTE:
The LaneSense system operates with the
similar behavior for a right lane departure.
Changing LaneSense Status
The LaneSense system has settings to adjust
the intensity of the torque warning and the
warning zone sensitivity (Early/Medium/Late)
that you can configure through the Uconnect
system screen.
Refer to “Uconnect Settings” in “Multime-
dia” in your Owner’s Manual for further infor-
mation.
NOTE:
• When enabled the system operates above
37 mph (60 km/h) and below 112 mph
(180 km/h).
• Use of the turn signal suppresses the warn-
ings.
• The system will not apply torque to the
steering wheel whenever a safety system
engages (anti-lock brakes, traction control
system, electronic stability control, forward
collision warning, etc.).
PARKVIEW REAR BACK UP CAMERA
The ParkView Rear Back Up Camera allows
you to see an image of the rear surroundings
of your vehicle whenever the gear selector is
put into REVERSE or whenever it is manually
activated. When the gear selector is put into
REVERSE, the image will be displayed in the
Uconnect screen along with a caution note to
“check entire surroundings” across the top of
the screen. After five seconds this note will
disappear.
Manual Activation Of The Rear View Camera:
1. Press the "Controls" button located on the
bottom of the Uconnect display.
2. Press the "Backup Camera" button
to turn the Rear View Camera system on.
When the vehicle is shifted out of REVERSE
(with Camera delay turned off), the rear Cam-
era mode is exited and the navigation or audio
screen appears again.
When the vehicle is shifted out of REVERSE
(with Camera delay turned on), the rear Cam-
era image will be displayed for up to 10 sec-
onds after shifting to another gear, unless the
vehicle speed exceeds 8 mph (13 km/h), the
transmission is shifted into PARK, the igni-
tion is switched to the OFF position, or the
touchscreen button “X” to disable display of
the Rear View Camera image is pressed.
Whenever the Rear View Camera image is
activated through the "Backup Camera" but-
ton in the "Controls" menu, and the vehicle
speed is greater than, or equal to, 8 mph
179