ESP-SMT Smart Modular Control System
55
Installation
This section provides information on how to install the ESP-SMT Controller.
F
CAUTION:
To
minimize
electromagnetic
interference, select a location at least 15 feet (4,6 m)
away from high-draw motors, such as air conditioners
or refrigerators.
Never share a 120 VAC circuit with pumps, motors,
shop tools, etc. as they may interfere with the correct
operation of the controller.
Installing The Controller
Select Location
Select a location that has a flat, stable surface in an area
protected from vandalism.
A
Using the mounting template, mount the controller at
eye level and allow at least 11” of horizontal clearance
so the hinged cabinet door can swing fully open to
the left.
B
Allow enough clearance for electrical conduit and
connections at the bottom of the plastic cabinet.
C
Select a location that has access to 120 VAC electrical
power.
It is best to run a dedicated circuit for the controller;
one that cannot be turned off by a light switch.
!
NOTE:
Select a location that allows the
communication wire (a pair of #16 AWG or #18AWG
UV rated wire maximum distance 200 feet) to be easily
run from the ESP-SMT controller to the SMT Weather
Sensor.
!
NOTE:
The ESP-SMT controller must be installed in
compliance with local electrical codes. Indoor models
must be installed indoors only. Outdoor models (with
locking cabinets) may be installed either indoors or
outdoors.
ALARM
ENGLISH
ESPAÑOL
ENGLISH
ESPAÑOL
ESP-SMT
SMART MODULAR CONTROLLER
FINE-TUNE
WATERING
SET DATE
& TIME
AUTO
SPECIAL
FEATURES
SYSTEM
REVIEW
INPUT ZONE
INFORMATION
CONFIGURE
CONTROLLER
RESTORE
SETTINGS
MANUAL
WATERING
OFF
11"
3"
B
C
A