![background image](http://html1.mh-extra.com/html/rae/toxirae-pro-co2/toxirae-pro-co2_user-manual_3363938057.webp)
ToxiRAE Pro CO
2
User’s Guide
55
17.3. Removing And Installing The Rubber Boot
The protective rubber boot on the ToxiRAE Pro CO
2
must be removed before the sensor
top cap or back of the instrument can be removed. When removing the boot, follow these
steps outlined here.
1.
Flip up the tab on the belt clip on the rear of the instrument.
2.
Remove the Philips screw that holds the clip in place.
3.
Stretch the bottom corners of the boot and gently slide the bottom of the boot over
the rear of the ToxiRAE Pro CO
2
.
4.
Slide the boot up until it comes off of the instrument. Make sure that you do not
force it to move if it sticks against the top cap. Gently nudge it.
5.
Inspect the rubber boot for damage, and replace it if it is cracked or torn.
When replacing the boot, simply reverse the procedure, sliding the boot onto the
instrument and then carefully stretching it over the bottom portion of the instrument. Do
not forget to replace the belt clip.