Radyne DMD2050, Operation Manual

Page: 93 / 214

User Interfaces DMD2050 Universal Satellite Modem
4-36 TM110 - Rev. 1.3
HI STAB VCO ADJUST {0% - 100%}
Allows the user to adjust the internal frequency
reference for calibration. Only displayed if the system
reference clock source is HI STABILITY.
LARGEST
HB GAP Used for factory test only.
SOFT RESET {ENTER}
Resets the modem.
IF BOARD (menu) Indicates the Radyne part number for the IF Board
Assembly.
AGC/CTRL/VALUE
{0% - 100%}
Allows the user to adjust the internal frequency
reference for calibration. Only displayed if the system
reference clock source is HI STABILITY.
I
OFFSET Used for factory test only.
Q
OFFSET Used for factory test only.
IF RX LVL OFFSET Used for factory test only.
LB RX LVL OFFSET Used for factory test only.
POWER SOURCE Used for factory test only.
TERR INTFC BRD Indicates the Radyne part number for the Terrestrial
Interface Assembly.
CODEC BOARD (menu) Indicates the Radyne part number for the Codec Board.
TPC
FPGA IMAGE Used for factory test only.
RS
FPGA IMAGE Used for factory test only.
TPC CODEC IMAGE Used for factory test only.
FEATURES
(menu)
5012.2840.2417
{____.____.____}
Allows the user to install purchased feature
upgrades (see Appendix A).
Whether or not the feature has been upgraded, or if the
feature requires a hardware upgrade (contact the
Radyne Customer Service Department).
UPGRADE LIST (menu) The following menu screens display the following:
10 MBPS, 20 MBPS, 52 MBPS (The highest option installed will hide the
lower rates.)
RXIF
RXLBAND