Radyne DMD2050, Operation Manual

Page: 203 / 214

Appendix F DMD2050 Universal Satellite Modem
F-2 TM110 – Rev. 1.3
d. IP TEST: The IP Test selection is similar in behavior to the Default selection.
When enabled, the following preset parameters will be programmed and will not
change until the selection is changed. To edit these parameters, change the
boot mode to NON-VOL.
ƒ
IP MASK 255.255.255.000
ƒ
MODEM IP ADDR 192.168.000.238
ƒ
SERVER IP ADDR 192.168.000.101
ƒ
ROUTER IP ADDR 192.168.000.102
The DMD20/20LBST is shipped from the factory with the Boot Mode
configured as Default. Verify that the Boot Mode is set for Default. To
access the unit via the Ethernet port, set the selection to IP TEST. This will
set the IP parameter to an accessible address. If user wants to utilize an
alternate address, user must set the selection to NON-VOL. As an example,
we will use a new modem IP address of 172.018.100.205 for the remaining of
the TCP-IP setup procedure. Contact the IT manager for proper guidance to
ensure setup is successful.
2. BOOT SERVER TAG: This allows for the selection of the operating boot tag when
operating in the BOOTp Mode. The default setting of 206 is automatically selected when
the boot mode is set to ‘DEFAULT’ (factory preset mode).
3. MODEM HOST: This displays the unit Host name that is operating, such as “DMD20”.
This is a read only display.
4. IP ADDR MASK: This will allow for the entry of the IP Address Mask. This will need to
be entered based on the Network settings. Refer to your IP Administrator if you do not
know this address for the correct address setting. Example IP Address Mask setting:
255.255.000.000.
5. MODEM IP ADDR: This will allow for the entry of the Modem‘s individual network IP
Address. Each device on the network will have a unique address. Refer to the IT
administrator for the correct address setting. Example Modem IP Address setting:
172.018.100.215.
6. SERVER IP ADDR: This allows for the setup of the Network Server IP Address. This
section refers to the Host that will be used to optionally boot the DMD20 on power-up and
is the SNMP Trap Server. This IP Address needs to be consistent with the Modem IP
Address. Broadcast and loop back addresses will not be allowed. Example Server IP
Address setting: 172.018.004.250.
7. ROUTER IP ADDR: This allows for the setup of the Network Router IP Address. If a
router is present on the local network, and it is to be used, this address must be
consistent with the IP Address Mask and the subnet of the modem. If no router is
present, then the address should be set to a foreign address. Broadcast and loop back
addresses will not be allowed. Router not used example: Router IP Address setting:
010.000.001.001.