MIB Parameters
Appendix F
RADWIN 1000/2000/5000 User ManualVersion 2.5.30p3
F-4
MIB Parameters
The following section describes all of the MIB parameters. The MIB parame-
ters follow the following naming convention:
<winlink1000><Section 1>...<Section n><Parameter Name>
For each of the configuration and control parameters (parameters with
read-write access), the “Description” column describes when the new value
is effective. It is recommended that you perform the appropriate action to
make the values affective immediately after any change. Where a change is
required on both sides of the link, it is recommended that you change both
sides of the link first and then perform the action.
Supported Variables from the RFC 1213 MIB
Table F-1: Supported RFC 1213 Variables (Sheet 1 of 2)
Name
OID
Type
Access
Description
ifIndex
.1.3.6.1.2.1.2.2.1.1.x
a
Integer
RO
A unique value for each interface.Its value ranges
between 1 and the value of ifNumber.The value for
each interface must remain constant at least from
one re-initialization of the entity's network
management system to the next re-initialization.
ifDescr
.1.3.6.1.2.1.2.2.1.2
DisplayString
RO
A textual string containing information about the
interface.This string should include the name of
the manufacturer, the product name and the
version of the hardware interface.
ifType
.1.3.6.1.2.1.2.2.1.3
Integer
RO
The type of interface, distinguished according to
the physical/link protocol(s) immediately `below'
the network layer in the protocol stack.
ifSpeed
.1.3.6.1.2.1.2.2.1.5
Gauge
RO
An estimate of the interface's current bandwidth in
bits per second.For interfaces which do not vary in
bandwidth or for those where no accurate
estimation can be made, this object should ontain
the nominal bandwidth.
ifPhysAddress
.1.3.6.1.2.1.2.2.1.6
Phys-Address
RO
The interface's address at the protocol layer
immediately `below' the network layer in the
protocol stack. For interfaces which do not have
such an address (e.g., a serial line), this object
should contain an octet string of zero length.
ifAdminStatus
.1.3.6.1.2.1.2.2.1.7
Integer
RW The desired state of the interface. The testing(3)
state indicates that no operational packets can be
passed.
ifOperStatus
.1.3.6.1.2.1.2.2.1.8
Integer
RO
The current operational state of the interface. The
testing(3) state indicates that no operational
packets can be passed.
ifInOctets
.1.3.6.1.2.1.2.2.1.10.x
Counter
RO
The total number of octets received on the
interface, including framing characters.
ifInUcastPkts
.1.3.6.1.2.1.2.2.1.11.x
Counter
RO
The number of subnetwork-unicast packets
delivered to a higher-layer protocol.
ifInNUcastPkts
.1.3.6.1.2.1.2.2.1.12.x
Counter
RO
The number of non-unicast (i.e., subnetwork-
broadcast or subnetwork-multicast) packets
delivered to a higher-layer protocol.
