Radwin 2000+ SERIES, User Manual

Page: 69 / 276

RADWIN 2000+ Series User Manual Release 4.2.40 5 ‐ 5
Log ‐ On with Local Connection
5.3.3 Log ‐ On with Local Connection
Alternatively, you can log on using Local Connection ( Figure 5 ‐ 2 ) without having to change
your Network Interface Card address.
5.4 Other Log ‐ on Options
SNMPv3: RADWIN 2000+ Series supports SNMPv1 and SNMPv3 either separately or
together. The log ‐ on procedure differs slightly between operation under
SNMPv1 and SNMPv3. Table 5 ‐ 2 shows the difference between SNMPv1 and
SNMPv3 at log ‐ on time.
User Types: The RADWIN Manager provides three levels of access in one of two entry
modes. To see them, click Options at any time in the Log on window ( Figure 5 ‐
2 above). You are offered an extended log ‐ on window:
• The Local Connection method uses broadcast packets to “discover”
the attached radio unit.
• If you log on using Local Connection , but your physical connection is
not local, then any configuration you carry out may affect other links
in the network. Do not do this!
• Do not carry out this procedure using a multi homed managing com ‐
puter also connected to a network. It will flood the network with
broadcast packets. Further, it will throw any other links on the net ‐
work into Installation or Inactive mode.
• As a precaution, default log ‐ on over Local Connection is read ‐ only
mode. Check the Read/Write enable box to carry out installation pro ‐
cedures.
• Network log on (IP address to the radio unit) is recommended.