RADWAG MYA.3Y, User Manual

Page: 66 / 132

- 66 -
DOSING
A criterion for enabling a bargraph is setting:
− A quick access key for “Dosing” mode
− Information item “Bargraph” in the workspace area to YES.
On enabling the above two parameters, a bargraph is added to the display and it is
located below the measurement result. Colour of the bargraph indicates the current
number of parts in relation to the target value.
For enabling the filling mode, press a
quick access key and specify the target
number of parts. The entered value must
be a total one, e.g. 50 pcs.
If any value with a decimal place is saved
in the memory, then the balance acquires
only a total value for filling process. When
counting parts, the bargraph indicates
current number of parts in a form of a
coloured progress bar.
Acceptance field – the result of counted
parts is recognized as correct if it is within
+/- 10% tolerance of the target value.
− Number of parts below the
acceptance field
− Number of parts within the
acceptance field and
+/- 10% of the target mass
− Number of parts above the
acceptance field
Bargraph colours:
− yellow: mass below the low threshold
− green: mass within the set thresholds
−
red: mass above the high threshold
Caution:
In case both the checkweighing and dosing modes are enabled, the display contains two
bargraphs.