Digital BUS-WATCH
®
R1001 / R4001
WARNING
DISCONNECT VEHICLE BATTERY VOLTAGE BEFORE INSTALLING
SYSTEM WIRING
WARNING
DISCONNECT POWER TO THE DIGITAL BUS-WATCH® BEFORE
JUMP STARTING VEHICLE
WARNING
INSTALL DVR HORIZONTALLY. USE EXTERNAL SHOCK AND
VIBRATION DAMPENING IF NEEDED.
System Wiring – Power and Camera Cables
Note: All cables should be hidden from view.
For the basic system (shown in Figure 11 on Page 21), there are five
cables, one power (P/N 512002 – 16 Feet, or 512001 – 35 Feet) and 4 camera
(P/N 510993 or any different length cable). For external record indication and
alarm/event marking, the Record Indicator / Event Mark Button Harness (P/N
511986) is available (shown in Figure 12 on Page 22). The GPS Harness (P/N
710144) is used for satellite location and movement information (shown in Figure
13 on Page 23). For additional vehicle monitoring, the BUS-WATCH® Vehicle
Sensor Options harness (P/N 512008) is available (shown in Figure 15 on Page
24).
Connect the camera(s) using cable P/N 510781, or equivalent. There is no
specific orientation for camera cables to be installed. If multiple types of cameras
are installed in a single system, be careful to note which cameras are located
where. Use lenses with more magnification (8mm) for to bring objects closer that
are far away. Use lenses with less magnification (4mm) for wide angle viewing.
Connect power using cable P/N 512002, or equivalent. The black wire
connects to the negative terminal of the battery. The white wire (labeled 12V
Battery) connects directly to the positive terminal of the battery.
The red wire
Page 20 of 96
Radio Engineering Industries, Inc.
640370 -- Rev 0 -- 8/17/2007
