Digital BUS-WATCH
®
R1001 / R4001
should be fused at 10 Amps if using a 7 or more camera system with a Quad
Video Processor (P/Ns 700483 or 700848).
Connect any Quad Video Processors (P/Ns 700483 or 700848)
or Camera
Switching Devices (P/N 700462 or 710030) as needed for multiple camera
systems.
IF THE SYSTEM OPERATES IN THE MANUAL RECORD MODE,
connect the red wire (labeled 12V SW), to the switched side of the ignition
switch. The red wire should be fused at 1 A. The red wire is ignored if the system
is in TIMER record mode.
REAR
VIEW
TRIGGER
ACC
GPS
SENSORS
CAM1
CAM2
POWER
R
AUDIO OUT
CAM4
CAM3
VIDEO
OUT
L
C
C
F
ICP
*710134
4 CH DIGITAL BUS-WATCH
CAM1 2 3 4
POWER
*SWITCH MAY BE VEHICLE IGNITION
(UNSWITCHED)
TO BATTERY
VIA IGN SWITCH
TO BATTERY
OR USER INSTALLED TOGGLE SWITCH
*IGN
WHT
BLK
RED
*Connect WHITE wire DIRECTLY to the positive
terminal of the battery.
*Connect BLACK wire DIRECTLY to the negative
terminal of the battery.
CAMERA CABLES
POWER CABLE
CAMERAS
Note: White wire fused @ 7A (1-6 Cameras), 10A for more cameras; Red wire fused @ 1A.
System Wiring
Figure 11: System Wiring – Power and Camera Cables
Page 21 of 96
Radio Engineering Industries, Inc.
640370 -- Rev 0 -- 8/17/2007
