Digital BUS-WATCH
®
R1001 / R4001
The Digital BUS-WATCH® system will operate without any user setup
with the default settings, however, it may not show the correct time and date
(Factory Set to Central Standard Time). To set the correct date and time and to
program the system operation to your requirements, please refer to the
Menu
Configuration
section of this manual.
When accessing the Menu, it is necessary to connect a video monitor to
the Video jack on the front or back of the unit. REI recommends our battery-
powered 5-inch Color LCD monitor, P/N 690484.
Inserting the Hard Drive:
Turn the hard drive key to the unlocked and
off position. Insert the hard drive into the bay. Turn the hard drive key to
the locked and on position, as shown in Figure 8 on Page 15.
Removing the Hard Drive:
Turn the hard drive key to the unlocked and
off position. Gently remove the hard drive from the bay.
Note: The Digital BUS-WATCH
®
R1001 & R4001 will not function
properly if the hard drive key is in the unlocked or off positions. If there is
no hard drive present in the bay but the key is in the locked and on
position, the Digital BUS-WATCH
®
will still power up normally, the
menus can be accessed, etc.; however, the unit will not be able to record
any video.
Page 14 of 96
Radio Engineering Industries, Inc.
640370 -- Rev 0 -- 8/17/2007
