- 24 -
O
PERATOR
´
S
M
ANUAL
F
ITIS
120 M
9901.00.20EN00 - 05/2015
7.7 Gauge wheel adjustment
IMPORTANT:
Check the general condition of the wheels daily.
7.7.1 Tyre
pressures
IMPORTANT:
Regularly check the pressure of the tyres. The
pressure in the tyres must never be less than the
recommended min. tyre pressure.
Tyre size
Working pressure
pressure
bar / MPa
Maximum speed
km/h / mph
[
4.0 / 0.40
25 / 15
-
Follow the manufacturer's recommendations (values marked
RQWKHVLGHZDOORIWKHW\UHV
CAUTION:
$QRYHULQÀDWHGW\UHULVNVWREXUVW
$QXQGHULQÀDWHGW\UHULVNVFRPHRIIWKHULP
7.7.2
Tightening of wheel studs
-
The 1
st
time after 10 hours or 50 km.
-
Again after 10 hours or 50 km.
-
Check the torque before the start of the season
and every 50 hours during use.
7.7.3
Gauge wheel height adjustment
1
2
3
Legend
1 Gauge
wheel
2 Lynch
pin
3 Clevis
pin
Adjust the height of a wheel to control the depth of the rear of the
implement.
ʈ
Raise the wheel to increase the working depth.
ʈ
Lower the wheel to decrease the working depth.
Adjustment
ʈ
5HPRYHWKHVDIHW\SLQ
ʈ
5HPRYHWKHFURVVSLQ
ʈ
/RZHURUUDLVHWKHJDXJHZKHHO2QFHLWLVDWWKHGHVLUHG
KHLJKWUH¿WWKHFURVVSLQDQGLQVHUWWKHVDIHW\SLQLQLWV
KROH
7.7.4
Gauge wheel turnover speed adjustment
1
2
Legend
1 Gauge
wheel
2 Locking
bolt
7KHEROWOLPLWVWKHVSHHGRIWKHJDXJHZKHHOXQLWGXULQJ
implement turnover.
Adjustment
ʈ
/RRVHQWKHEROWWRIUHHWKHVWUXWGXULQJWXUQRYHU
ʈ
7LJKWHQWKHEROWWRUHGXFHWKHWXUQRYHUVSHHG
IMPORTANT:
Over-tightening the bolt (2) may prevent gauge
wheel unit turnover.
