R-sensors LLC
Bldg. 1, 4, Likhachevsky proezd, Dolgoprudny, 141701, Russia
+7 (498) 744-69-95,
NDAS-N. User Manual.
25
●
Signal is the main tab that contains windows of the displayed charts and tables
●
Buffer is a tab that allows configuring the size of the signal buffer and downloading the data
stored in the buffer
●
Devices is a tab that displays the status information about the connected signal sources
●
Connections is a tab that contains a list of addresses to connect to signal sources
●
Profiles is a tab that contains a list of profiles of module’s user settings
Fig. 6.1. RT Viewer module. Control tabs
6.3. Start of operation
A short sequence of actions to start operating with the module is given below.
●
Click the
Connections
tab and add the required connections to the NJSP servers. Make sure the
connection is established, the connection status is
Connected
, the name and serial number of the
signal source corresponds to the connected device. Detailed information on the status of devices
can be found on the
Devices
tab.
●
Click the
Signal
tab and add the required number of windows containing waveforms, spectra,
and tables.
●
Add the required signals to the windows.
●
Click the
Buffer
tab and adjust the buffer size to download the saved data if necessary.
●
If necessary, go to the
Profiles
tab and save your module settings.
6.4. Connections tab. Connection to the signal source
To add a new NJSP signal source, click the Connections tab, enter the IP address and the NJSP port
number. In case of local connection (to a signal source located on the same NDAS-RT device), use IP
address 127.0.0.1. Then click the
add connection
button.
