R-sensors LLC
Bldg. 1, 4, Likhachevsky proezd, Dolgoprudny, 141701, Russia
+7 (498) 744-69-95,
NDAS-N. User Manual.
19
5. Onboard ADC program module. ADC configuring
The
Onboard ADC
module is used for viewing status and setting parameters of the data logger’s
main and auxiliary ADCs.
The module has the following basic functionality:
●
Display of the main ADC synchronization status;
●
Control of the test signal output;
●
Settings of the main ADC parameters;
●
Settings of the auxiliary ADC parameters.
5.1. Start of the Module
Click the Config tab on the NDAS-RT main interface. Find the line of the Onboard ADC module,
click the
enable
button in this line (see Fig. 5.1).
If the information in the line has not been updated, click the
refresh state
button in the upper right
corner of the screen.
At the initial start the data logger module may display an ADC error message. This message
will disappear after any active configuration is set up and saved.
To open the module web interface, click the
config
button in the corresponding line.
Fig. 5.1. Onboard AD
С
module. Enabling and configuring
