9
R-Biopharm
Self Test
RIDA
®
QUICK SCAN
V 1.0.0.8 2009.01.18.
UserID
User01
◄
Method
DON CutOff
Cut off0.50
Start scan
►
16
°C
18.01.09 B 09:00 pm
▼▲
Scan mode
UserID
User01
◄
Method
DON CutOff
Cut off0.50
Start scan
►
16
°C
18.01.09 B 09:00 pm
▼▲
Scan mode
3 Using the RIDA
®
QUICK SCAN reader
3.1 Switching the device on
To switch the device on, press the ENTER key (3) for around 1 second. The following start
menu is displayed and the device performs an internal test (Figure 3). After this short internal
test the Scan Mode is displayed (Figure 6).
The current status of the power supply is shown beside the battery symbol. "B" stands for
battery operation and "N" means that the device is connected to a mains power supply (the
batteries are being recharged). The batteries are recharged only when the device is switched
on.
Figure 5 a
Figure 5 b (Example: Cut Off)
Besides Scan Mode you can also choose between the following modes by pressing the
◄►
keys:
-
Setup Mode:
Basic device function settings
-
Memory Mode:
Display stored test measurements
-
Calibration Mode:
Check the Calibration of the reader
These modes are described in more detail below. The actually measured temperature is
shown on the display. The tests should be performed at room temperature.
3.2 Evaluate test strip (SCAN MODE)
The test strips are measured in Scan Mode. When you have switched on the reader you must
define or confirm the displayed parameters before you perform the first measurement.
To do this, select the individual entry fields with the cursor keys
▲▼
and then change the
parameters using the
◄►
keys.
Figure 6
User:
Select user
Method:
Select test
Cut Off:
Define required detection limit.
