Qvis APOIR-PTZ23, User Manual

Page: 12 / 56

© Copyright Qvis® All documentation rights reserved.
4
2 IR PTZ camera Installation
2.1 Installation Preparation
Basic Requirement

All installation and operation procedures should conform to your local electrical safety codes.

Before installation, please open the package and check that all the components are included. Please make
sure the PTZ camera installation environment and installation mode can meet your requirement.

We assume no liability or responsibility for any type of damage to person(s) or property caused by improper
handling or installation.
Check installation space and installation location intension
Please make sure the installation environment has enough space to install the PTZ camera and its
corresponding bracket. Also make sure the ceiling, wall and the bracket can support the PTZ camera and its
corresponding installation component. Only install on to the surface if it can take 4X the weight of the camera.
About cable
Please select the cable according to your transmission distance.
The minimum video coaxial-cable requirement is:

75 ohm.

Full cable with copper conductor

95% knitted copper shield
International Model Max Distance
(Ft\M)
RG59/U 750ft (229m)
RG6/U 1,000ft (305m)
RG11/U 1,500ft (457m)
Set dial switch button
Set dial switch button according to control protocol and PTZ camera address (see Chapter 8 for full instructions).
Please keep all package material well for future use
Please keep PTZ camera package material in good condition in case you need to send it back to your supplier.
Non-original packaging material may result in device damage during the transportation.
Check Accessories
Before the installation, please check the accessories one by one according to the packing list. Please make sure
all the components listed are included