Quest Engineering MPS 3, Operation Manual, Page: 78 / 268

MPS 3 System – System Installation
5.6.2. Connecting to the Electronic Data Management System
(EDMS)
The MPS 3 System may be connected to a third party Electronic Data Management
System to export Case Log and Dose History data. Because there are a variety of
EDMS systems, please consult your sales representative to determine which EDMS
Cable is needed for your setup.
To connect the EDMS Cable to the MPS 3 System, please follow the following steps.
1. Verify that the EDMS is compatible with the MPS 3 System.
2. Verify that the EDMS Cable provided has the correct connections for your
EDMS system.
3. Connect the EDMS Cable to the appropriate port on the EDMS system.
4. Remove the supplied cover from the USB or RS-232 port (depending on the
cable required). Retain the cover for use if the cable is to be removed.
5. Connect the EDMS Cable to the USB or RS-232 port (depending on the cable
required) on the rear panel of the MPS 3 Controller.
Figure 34: EDMS Ports on MPS 3 Controller
Before connecting the MPS 3 System to the Electronic Data
Management System (EDMS), consult the EDMS service
provider to understand the data interface requirements and
compatibility.
Avoid OPERATOR INJURY. Only qualified technicians
should attempt to connect the EDMS Cable to the MPS 3
System. Ensure that all fingers are free from pinch / crush
hazards while connecting the EDMS Cable.
36
RS-232 Port
USB Port