Quest Engineering MPS 3, Operation Manual, Page: 63 / 268

MPS 3 System – System Installation
5.5.3.1.
To install the MPS 3 Controller using the Telescoping Mounting Arm (P/
N 5303008) on the HLM Pole, follow these steps:
1. Consult the HLM Operation Instructions prior to attempting to install the MPS 3
Controller to ensure the Controller can be safely installed.
2. Once a placement location has been identified, clean and tidy the area and
install the MPS 3 Controller Telescoping Mounting Arm.
3. To install the Telescoping Mounting Arm, loosen the pole clamp by turning the
handle counterclockwise so that it fits over the pole / mast intended to be used
for installation.
Figure 20: Loosen Pole Clamp and Position Clamp over Pole
4. Position the pole clamp over the pole and tighten the pole clamp by turning the
handle clockwise. Tighten the pole clamp hand tight so that it is secure, but not
overtightened. Test the securement of the pole clamp to the pole prior to
installing the MPS 3 Controller. Ensure the quick release mounting adapter is
oriented upwards.
21
This Way Up