EN
.
45
ⓘ
NOTE: This product can be included and operated in any Z-Wave network with other Z-Wave
certified devices from any other manufacturers. All constantly powered nodes in the same
network will act as repeaters regardless of the vendor to increase reliability of the network.
ⓘ
NOTE: This device must be used in conjunction with a Security Enabled Z-Wave Controller to
fully utilize all implemented functions.
ⓘ
NOTE: This device is a security enabled Z-Wave Plus product that can use encrypted Z-Wave
Plus messages to communicate to other security enabled Z-Wave Plus products.
ⓘ
NOTE: DSK access via UI
Gateways, which implement the S2 and Smart Start security feature, display an input dialog box,
with a full or partial DSK key. Most of them display a partial DSK (they do not show the PIN code)
when the device is included with the S2-Authenticated security scheme. When included with the
S2-Unauthenticated, some gateways show the complete DSK while others perform the complete
inclusion process without prompting the user with the dialogue.
ⓘ
NOTE: MAPPING OF COMMAND_CLASS_BASIC
The COMMAND_CLASS_BASIC is mapped into COMMAND_CLASS_SWITCH_MULTILEVEL, on the
root endpoint and endpoint1. On endpoint2, COMMAND_CLASS_BASIC is mapped into
COMMAND_CLASS_SWITCH_BINARY, for enabling relay control:
On the root endpoint and endpoint1
, the 4 LEDs will be turned ON or OFF after receiving the
BASIC_SET command:
-
they will be turned on, when the device receives a BASIC_SET(Value=0x01-0x063) (1-99%)
-
they will be turned on to the last non-zero value, when the device receives a
BASIC_SET(Value=0xFF)
-
they will turn off, when the device receives a BASIC_SET(Value=0x00)
On endpoint2
, the relay will be turned ON or OFF, after receiving the BASIC_SET command:
-
the relay will be turned on, when the device receives a BASIC_SET(Value=0x01-0x063) (1-
99%)
-
the relay will also turn on, when the device receives a BASIC_SET(Value=0xFF)
-
the relay will turn off, when the device receives a BASIC_SET(Value=0x00)
ⓘ
NOTE: Answering on a METER_GET_V1 command:
When the device receives a METER_GET_V1 command, it will answer with a METER_REPORT_V4,
with the field values rateType=1 and scale=0 (kWh).
