EN
.
34
12.3.
Removing the device from a Z-Wave network (Exclusion)
NOTE:
check chapter 5.4
1. Connect the device to the power supply.
2. Make sure the device is within direct range of your Z-Wave gateway (hub) or use a hand-held
Z-Wave remote to perform exclusion.
3. Enable add/remove mode on your Z-Wave gateway (hub).
4. Press once on button 3
–
right. One press on button 4
–
down for enabling full white. When
full white is enabled, press, and hold button 3
–
right for 5 seconds. After 5 seconds, the device
starts flashing red 1 second ON, 0.5 second OFF.
Once the device loses node ID (after 10 seconds), it stops flashing and turns full red. The
procedure is always available.
NOTE1: LEARN MODE state allows the device to receive network information from the
controller.
12.4.
Device factory reset
NOTE:
check chapter 5.4
1. Connect the device to the power supply.
2. Press once on button 3
–
right. One press on button 4
–
down for enabling full white. When
full white is enabled, press, and hold button 5
–
left for 10 seconds. After 10 seconds, the device
starts flashing blue 1 second on, 0.5 second off.
After 10 seconds the device stops flashing and turns full blue.
The procedure is always available.
ⓘ
By factory resetting the device, all custom parameters previously set on the device will
return to their default values, and the node ID will be deleted. Use this reset procedure only when
the main gateway (hub) is missing or otherwise inoperable.
