EN
.
10
5.2 Measurements and reporting
Measurements and reporting are only available for relay output.
Watt Power
–
Active
kWh Energy
–
Active power accumulated
Energy consumption in kWh is reported in 0.1 kWh resolution.
Active power in W is reported in 1 W resolution.
NOTE:
For more options check parameter nr. 40.
5.3 Overload protection
Overload protection defined by user
The user has an option with parameter 70 to set an overload safety threshold. The threshold is set to 2300
W by default. If the power exceeds it for 5 seconds the Luxy Smart Switch relay will turn off, and a
“Overload detected” notification will be sent.
Controlled device can be turned back on by capacitive
antenna/s or sending a control frame.
Overload safety protection
Overload safety protection is triggered if the load exceeds 10 A (2400 W) for more than 5 seconds. If the
overload safety protection is triggered, the device will shut down the relay and start flashing red (1 sec
ON, 0.5 sec OFF) and sends an overload notification message. Device is not responsive to touch
commands or Z-wave commands. Controlled device can be turned back on with power cycle (mains cut
off).
5.4 Lock touch functions for enabling output ON/OFF
This option enables/disables ONLY the touch functionality for closing/opening the relay output meant for
switching ON/OFF the connected light or other connected load. While enabled, other touch functionalities
are temporary unavailable. The option can be accessed:
Locally
:
•
You can choose any kind of light (also no light) except FULL white. Press and hold button 3
–
right
in between 6 to 9 seconds. Release the button.
•
To revert the option, repeat the above procedure.
Remotely
:
•
Check the
Parameter no. 60
–
Lock touch for relay only.
Set value to 1 (enable) or 0 (disable) the
option.
NOTE: Your gateway needs to support advanced configuration and parameter input to
use this feature.
