EN
.
41
•
Default value 10
•
0 - Power consumption reporting disabled
•
1 - 100 = 1 % - 100 % Power consumption reporting enabled. New value is reported only
when Wattage in real time changes by more than the percentage value set in this
parameter compared to the previous Wattage reading, starting at 1 % (the lowest value
possible).
NOTE: Power consumption needs to increase or decrease by at least 1 Watt to be reported,
REGARDLESS of percentage set in this parameter.
Parameter no. 42
–
Watt Power Consumption Reporting Time Threshold for Load
Set value refers to the time interval with which power consumption in Watts is reported (0
–
32535 seconds). If 300 is entered (by default), energy consumption reports will be sent to the
gateway (hub) every 300 seconds (or 5 minutes).
Values (size is 2-byte dec):
•
Default value 0
•
0 - Power consumption reporting disabled
•
30 - 32535 = 30 - 32535 seconds. Power consumption reporting enabled. Report is sent
according to time interval (value) set here.
Parameter no. 60
–
Lock touch for relay only
This parameter enables ONLY the touch functionality for closing/opening the relay meant for
switching ON/OFF the connected light or any other connected load. See chapter 5.4 for
additional information.
Values (size is 1-byte dec):
•
Default value 0
•
0
–
disabled
•
1
–
enabled (the user can switch ON/OFF the connected light or any other connected
load by touching ANY button. Other functionalities (lighting mode, scenes, dimming and
full white, inclusion/exclusion and reset) are unavailable until function disabled).
Parameter no. 70 - Overload safety switch
The function allows for turning off the controlled device in case of exceeding the defined power
for more than 5 sec. Controlled device can be turned back on by capacitive antenna/s or sending
a control frame.
Values (size is 2-byte dec):
