Quasar CM-6208 User and Installation Guide
40
5.
Copy the PEM-formatted request and send it to your CA.
Note:
The self-signed certificate does not provide the same high level of security as a
certificate issued by a Certificate Authority (CA).
IP Filter
The IP filter restricts access to the camera by denying/allowing specific IP addresses. Click the
IP
filter
tab under the category
Security
in the sidebar to display the following page.
Figure 44: IP Filter Screen
To enable the IP filter
1.
Check the box to enable the IP filter function. Once enabled, the listed IP addresses (IPv4)
are allowed or denied access to the camera.
2.
Select
Allow
or
Deny
from the drop-down list.
3.
Click
Apply
to determine the IP filter behavior.
To add or delete an IP address
1.
Enter the IP address in the
Filtered IP Addresses
text box.
2.
Click
Add
to add a new filtered address. The
Filtered IP Addresses
box shows the currently
configured IP addresses. Up to 256 IP address entries may be specified.
3.
To remove an IP address from the list, select the IP address and then click
Delete
.
