ATL P1000 Series Library Unpacking Instructions
Document 6221100-02, Ver. 2, Rel. 0
March 1999
Installing the Slide Assembly in the Rack
21
Procedure (continued)
e
Use a Phillips screwdriver to tighten the screw while holding
its corresponding nut with an 11/32 inch open-ended wrench.
f
Repeat steps 3d and 3e to tighten the remaining inner nuts.
g
Push the slide assembly tray back into the rack.
4
Check for adequate clearance. If necessary, repeat this procedure to
adjust the slide tray further.
Now that the slide assembly is properly installed and adjusted, you
are ready to remove the P1000 from the shipping pallet and mount it in
the rack.