![background image](http://html1.mh-extra.com/html/quantum/lto-8-hh-sas/lto-8-hh-sas_technical-reference-manual_3839997036.webp)
Chapter 3: Installation
Connect Power
28
QuantumLTO-8 HH SAS User’s Guide
Figure 6 Example of
connecting the SAS device to
two servers
4
Ensure the host adapter and the server are configured correctly for a
SAS bus operation. Refer to the host adapter and server
documentation for instructions.
5
If the power cord has already been installed, turn power to the tape
drive ON.
Connect Power
1
If the power cord has already been installed, skip to step 3.
2
Plug the power cord into the rear panel (see
then plug the other end into a grounded electrical outlet.
3
Power-on the unit by pressing the
Power
button. The POST runs,
which checks all hardware except the drive head. During the POST,
the Single-character Display (SCD) flashes several segmented
1 Tape drive
4 SAS host adapter card
2 SAS connectors
5 Servers
3 SAS cables
Summary of Contents for LTO-8 HH SAS
