Quantum DXi6900-S, Field Service Manual

Page: 110 / 208

Chapter 3: FRU Removal and Replacement Procedures
Replacing Node Expansion Cards
Quantum DXi6900-S Field Service Manual 97
Illustration Description
Dual port 16 GB Fibre Channel card (QLogic)
Dual port 12 Gb SAS card (Dell)
Replacing an Expansion Card in Riser 1
This section describes how to remove and replace an expansion card in expansion card riser 1. The
following cards are located in riser 1 (see
Figure 63 on page 94 ):
Slot 1 (top) No card
Slot 2 (middle) Dual port 12 Gb SAS card (Dell)
Slot 3 (bottom) Dual port 12 Gb SAS card (Dell)
Caution: Use appropriate ESD precautions, including the use of a grounding strap, when performing
this procedure.
Removing and replacing an expansion card in expansion card riser 1 includes the following steps:
l
Removing an Expansion Card from Riser 1 below
l
Installing an Expansion Card in Riser 1 on page 100
Removing an Expansion Card from Riser 1
To remove a failed expansion card from riser 1:
1. Shut down the system (see Turning Off the DXi6900-S on page 21 ).
2. Remove the Node cover (see Opening and Closing the Node on page 63 ).
3. Disconnect any cables connected to the expansion card.