Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B
February 2014
Network CLI Commands
109
•
devno
: Device number, which can range from 0 to possibly 99,
depending on actual systems.
•
vifno
: Virtual interface number, which is optional and can range from 1
to possibly 99, depending on actual systems.
•
--network:
IP address in decimal dotted notation (e.g. 10.20.30.0).
•
--sure:
if specified, the command will execute without asking for
confirmation.
Listing Static Routes
syscli --list route
This CLI allows the user to display the static routes for the system.
--list:
Lists the static routes.
Creating a DHCP
Ethernet interface (for
V-Series)
syscli --add netcfg --devname <DEVNAME> --dhcp
This CLI allows the user to create a DHCP Ethernet interface.
--devname
: Where
<DEVNAME>
is a base port interface name such as
eth0
.
Note: <DEVNAME>
cannot contain a VIF or a VLAN tag, and static IP
configuration parameters, such as ipaddr, netmask, or gateway are not
allowed either.
Deprecated Network
CLI Commands
The following network CLI commands are deprecated:
•
•
•
•
Setting Up a Segmented Network
•
Setting Up an Unsegmented Network
•
•
Undoing a Network Configuration
Enabling Jumbo Frames
syscli --enable jumbo
DEPRECATED. Use the syscli
--add netcfg
command to set jumbo frame status
instead.
