Chapter 4 SCSI Commands
LOG SENSE Command (4Dh)
DLT-S4 Interface Reference Guide
95
Parameter
Code
(continued)
0005h
Drive temperature in degrees C.
0006h
Media ID of the most recently loaded cartridge.
0007h
Controller serial number (least significant 16 bits). The drive uses this
value to generate the Media ID for blank tape cartridges.
0008h
Drive cleaning cycle count.
0009h
Serial number of the first drive to write the current tape.
000Ah
Serial number of the last drive to write the current tape.
000Bh
Total number of event log entries that are available through log page
07h.
000Ch
Maximum number of parameter codes per event log entry in log page
07h.
000Dh
Maximum number of cleans on a cleaning cartridge.
000Eh
Number of drive power cycles.
000Fh
Power on time for this power cycle, in milliseconds.
0010h
Total drive power on time, in milliseconds.
0011h
Current Track Number.
7000h
TapeAlert flags bit map — See ADC specification INCITS 403-2005,
Table 17 - bytes 4-15.
8000h
Drive Lifetime media loads
8001h
Drive Lifetime media motion hours
8002h
Drive media motion hours since last clean
8003h
Periodic Cleaning Interval in media motion hours
8004h
Drive Lifetime GBs written to tape
8005h
Drive Lifetime GBs read from tape
9000h
Media Lifetime load count
9001h
Media Lifetime load count threshold
9002h
Media Lifetime wear passes
9003h
Media Lifetime wear passes threshold
9004h
Media Lifetime motion hours
9005h
Media Lifetime motion hours threshold
Parameter
Control Byte
Bit
Value
Description
DU
0
Disable Update.
Field
Description