![background image](http://html2.mh-extra.com/html/quantum/dlt-s4/dlt-s4_reference-manual_3531879185.webp)
Chapter 4 SCSI Commands
MODE SELECT (6) / (10) Command (15h / 55h)
DLT-S4 Interface Reference Guide
151
table 87
. Note that the parameter name may be in upper or lower case.
The drive saves the savable parameters during resets and power cycles.
Table 87 EEPROM Mode
Page — Parameter
Descriptions
Parameter
Data Type
Default
Length
(Bytes) Usage
VendorID
ASCII
QUANTUM
8
Vendor Identification field in
INQUIRY
data.
CacheTMs
Binary
0
1
When set, the drive always treats a
WRITE
FILEMARKS
command that writes a single
filemark and is not preceded by another
WRITE FILEMARKS
command as if the Immed
bit was set to 1.
DefaultCompON
Binary
1
1
When set to 0, indicates that compression is
defaulted OFF at power-on/reset.
When set to 1, indicates that compression is
defaulted ON at power-on/reset.
DefFixedBlkLen
Decimal
0
4
Default fixed block size. Minimum value of
this field is 0, maximum value is 16,777,215.
DefSEW
Binary
1
1
Default Synchronize at Early Warning
parameter.
DisDeferClnRpt
Binary
0
1
When set to 1, the drive sends a cleaning
report over the library port as soon as the
cleaning light illuminates. When set to 0, the
drive sends the report only at unload.
DisUnbufMode
Binary
0
1
When set to 1, the drive completely disables
unbuffered mode; it ignores the
MODE
SELECT
buffered mode selection to turn off
buffered mode. When set to 0, buffered mode
can be enabled or disabled.
EnaCleanLib
Binary
1
1
When set to 1, the drive reports cleaning
status using the library tape drive interface.
When set to 0, this functionality is disabled.