Quantum ATL SuperLoader ATL, User Manual

Page: 55 / 196

Chapter 3 Media Changer Commands
Inquiry Command (12h)
Quantum ATL SuperLoader Software Interface Guide 37
TrmlOP (DLT) 0 Terminate I/O Process. The media changer does not support
the TERMINATE I/O PROCESS message.
NormACA (LTO) 0 The media changer does not support the NACA bit in the
control byte of the CDB.
HiSup (LTO) 0 The hierarchical addressing model is not used.
Response Data
Format
2 This Standard Inquiry Data is in SCSI-2 format.
Additional Length 27h This field indicates the number of additional bytes of
INQUIRY Response Data available.
SCCS (LTO) 0 This device does not contain an embedded storage array
controller.
BQue (LTO) 0 Basic queueing is not supported.
EncServ (LTO) 0 This device does not contain an embedded enclosure services
component.
MultiP (LTO) 0 This device does not implement multi-port requirements.
MChangr (LTO) 0 This device is not an attached media changer.
MChnger (DLT) 0 Set to 1 if a Media changer (loader) is present and EEPROM
parameter EnblngMedChgr is set to 1. this SCSI-3 bit indicates
that the Read Element Status and Move Medium commands
can be issued to the drive (LON0). By default, this bit is set to
0.
Add16 (LTO) 1 This devices supports 16-bit wide SCSI addresses.
RelAdr 0 This device does not support relative addressing.
WBUS32 (DLT) 0 Set to 0 since the media changer does not support 32-bit
transfer.
WBUS16 1 This device supports 16-bit wide data transfers.
Sync 0 This devices does not support synchronous data transfers.
Field Name Value Description