QUANTA STRATOS S210 Series S210-X12RS, Technical Manual

Page: 208 / 272

C
HAPTER
T
ITLE
W
EB
G
RAPHICAL
U
SER
I
NTERFACE
(GUI)
FOR
ESMS
4-35
screenshot of Add Event Filter Page is in seen the
screenshot below.
Figure 4-25. Add Event Filter Entry Page
3. In the Event Filter Configuration section,

PEF ID displays the ID for configured PEF entry (read-
only).

In filter configuration, check the box to enable the PEF
settings.

In Event Severity, select any one of the Event severity
from the list.
4. In the Filter Action configuration section,

Event Filter Action is a mandatory field and checked by
default, which enable PEF Alert action (read-only).

Select any one of the Power action either Power down,
Power reset or Power cycle from the drop down list

Choose any one of the configured alert policy number
from the drop down list.
5. In the Generator ID configuration section,

Check Generator ID Data option to fill the Generator ID
with raw data.

Generator ID 1 field is used to give raw generator ID1
data value.

Generator ID 2 field is used to give raw generator ID2
data value.

In the Event Generator section, choose the event gen-
erator as Slave Address - if event was generated from
IPMB.Otherwise as System Software ID - if event was
generated from system software.

In the Slave Address/Software ID field, specify corre-
sponding I2C Slave Address or System Software ID.
Note:
Alert Policy has to be configured - under
Configuration >
PEF > Alert Policy
.
Note:
In RAW data field, to specify hexadecimal value prefix with '0x'.