511010 Rev. 07-01-19
Field–Replaceable Units (FRUs)
7-23
9.
With the library removed, use a Number 2 Phillips screwdriver to remove the
eight screws and their washers that secure the rack mounting rails to the rack
as shown in Figure 7-18.
Figure 7-18 Rack Rails being removed
10.
Set the screws, washers and rack rail assemblies aside in case they will be re-
used.
11.
IF the rack rail assemblies are NOT going to be placed into the exact same loca-
tion on the rack, remove the cage nuts from the two front rack posts.
7.14.2
Rack Mounting Kit Replacement
This procedure assumes that the Rack Mounting Kit was removed in Section 7.14.1.
1.
If the rack is not going to be placed into the same location, decide where the rack
rails are to be mounted. We recommend marking the position where each rack
rail assembly bracket is to be mounted.
2.
The rack rail assembly must be sized to fit the distance between the front and
rear rack posts. If the old rack rail assemblies are available and the rack depth
is the same they can be used as templates for the new rack rail assemblies.
Remove all 8 screws and washers to
remove the rack rail assemblies.
Possible Cage Nut Locations
Summary of Contents for RLS-8350
