501510 Rev. S
Field
–
Replaceable Units (FRUs)
7-13
Control Panel
Carriage Assembly
Handler
Front Panel/Door
Assembly
Use these holes for lifting
the Carriage Assembly.
Figure 7-4 Carriage Assembly shown with Front Panel/Door Top Cover Open
7.7.1
Carriage Assembly Removal Procedure
1.
Remove power from the RLS by first pressing the power switch off and then re-
moving the power cord (two power cords if dual-redundant power supply mod-
ules are installed).
2.
If the RLS is rack-mounted, follow the steps in Section 7.5.1 to extend the RLS
out of the rack.
3.
Follow the steps in Section 7.6.1
to open the library’s Top Cover.
4.
If the RLS is not rack-mounted, slide it forward far enough over the edge of the
table so that the Carriage Assembly screws located on the bottom of the library
can be accessed. See Figure 7-5.
5.
There are only two screws on the bottom of the RLS that secure the Carriage As-
sembly. Use a No. 2 Phillips screwdriver to remove the rear screw on the right
side and front screw on the left side as shown in Figure 7-5.
Remove these 2 Screws
Front
Left
Right
Summary of Contents for RLS-4124
