Qualstar RLS-4124, Technical & Service Manual

Page: 102 / 205

6-8 Troubleshooting
501510 Rev. S
6.3.12 Fan Failed
One of the two fans in the Power Supply Module is not turning at full speed. If the fan
is not obstructed (by cable ties, etc.), replace the entire Power Supply Module. The
RLS must be powered down to accomplish this task.
6.3.13 Supply Failed
This message should never occur with a 125 or 160-watt Power Supply Module. The
message indicates that one of the two power supplies within a 250-watt module has
failed and that only 125-watts of power is available. The RLS can generally function
on this limited power when only one or two drives are running. It may intermittently
fail when all drives are simultaneously busy loading, unloading or rewinding. Replace
the entire Power Supply Module. The RLS must be powered down to accomplish this
task.
6.4 Operating Error Messages
These error messages are caused by improper use of the library.
6.4.1 Gripper Full
The command failed because a move command was initiated that needed the Handler
empty but the Handler was full.
6.4.2 No Target Magazine
A move was initiated to a magazine that is not installed.
6.4.3 No Target Drive
A move was initiated to a cartridge Tape Drive that is not installed.
6.4.4 Target Full
A move was initiated to a destination that is already occupied.
6.4.5 Source Empty
A move was initiated from an empty source.
6.4.6 No Source Magazine
A move was initiated from a magazine that is not installed.