Qualstar RLS-4124, Technical & Service Manual

Page: 42 / 205

3-8 The Operator Interface
501510 Rev. S
A series of leading dots
indicates that the next
higher menu is the Top
Menu.
Display line one gives the title of the current menu or function.
The RLS will always try to spell out menu names as completely
as possible in the 20 characters available.
Figure 3-4 The Operation Menu
3.5 Menu Elements
3.5.1 Menu Items
Line 1 of any menu display always indicates the name of the menu right justified,
with the exception of the Top Menu, where menu names are left justified. The name
of, or an acronym for, the parent menu will precede the menu name and will be left
justified. Bullets fill the space between the two menu names. Examples:
LINE 1 DISPLAY INTERPRETATION
Top Menu
Top Menu
•••••••Configuration
Configuration Menu
CA•••••Control Panel
Configuration\Advanced\Control Panel Menu
CA•Changer•Inventory
Configuration\Advanced\Changer\Inventory Menu
OES••••••••••Display
Operation\Element Status\Display Menu
Lines 2 through 4 of any menu display may contain the following items:
Menu Name A Menu Name is displayed with a single leading bullet
and an upper/lower case name. Example:
.
Maintenance
Command Name A Command Name is displayed in all upper case letters
without a bullet or colon. Example:
SET TO DEFAULTS
Value Name A Value Name is displayed with an initial capital let-
ter, a colon after the name, followed by a right-justified
value field. Example:
Contrast: 48
Menu Name
with Status There are a few Menu Names that are followed by a
status message. This is indicated by colon after the
menu name followed by the status message, which
summarizes the state of the sub-menu about to be en-
tered. The status message is not editable. Example: