7-36
Field
–
Replaceable Units (FRUs)
501510 Rev. S
Front Panel/Door
AIT Tape Drive Carrier
Drive Latch Lever
Thumbscrew Fastener
Slots for Drives
Guiding Features (4)
Drive Latch Lever
Figure 7-20 Drive Carrier Orientation
–
AIT type shown
3.
With the Drive Latch Lever in its fully down position, slide the Tape Drive As-
sembly into its slot while gliding on the bottom of the carrier. Push gently until
it stops moving. Disregard the Inventory Sentry alarm if it sounds, as the inven-
tory will be rescanned when the Front Panel/Door is closed.
CAUTION
The RLS can be damaged by operating the Drive Latch Lever prematurely or by using
excessive force.
4.
Lift the Drive Latch Lever up, but do not use force. A detent should be felt about
half way through the lever’s travel.
5.
Engage the thumbscrew fastener and turn it clockwise until tight.
6.
Using both hands, close the Front Panel/Door.
7.
Proceed to the next section (7.11.3) to verify the new drive carrier is responding.
Summary of Contents for RLS-4124
