7-10
Field
–
Replaceable Units (FRUs)
501510 Rev. S
7.5.1
Extending the RLS from the Rack
1.
Remove power from the RLS by first pressing the power switch off and then re-
moving the power cord (two power cords if dual-redundant power supply mod-
ules are installed).
2.
Disconnect any cables that may prevent the library from being extended fully.
3.
Open the Front Panel/Door as described in Section 7.4.
4.
Use a No. 2 Phillips screwdriver to remove the two screws that secure the RLS
to the front rack posts. See Figure 7-2.
5.
Carefully extend the RLS outward from the rack until its slides lock in the ex-
tended position.
Front Rack Rails
Front Panel/Door
Screws to secure the RLS to
the front rack posts.
Hinged Top Cover
Retract
Extend
Figure 7-2 Detail of the Extension Prevention Screws
7.5.2
Retracting the RLS into the Rack
1.
Unlock the latches found on each rack slide by lifting slightly and pushing the
RLS inward slightly.
2.
Carefully push the RLS into the rack until seated.
Summary of Contents for RLS-4124
