QuadroE1/T1 Manual I: Installation Guide
Installing QuadroE1/T1
QuadroE1/T1; (SW Version 3.2.x)
10
Connecting the Hardware
Fig. I-4: Connecting the Hardware
•
Verify the product package contents are complete. Refer to the contents sheet included
in the packaging to determine if all the items were shipped in the box.
•
Connect a telephone to the PHONE port on the QuadroE1/T1’s rear panel.
•
Connect the QuadroE1/T1’s E1/T1 port to your PBX or the trunk from the PSTN
Central Office ONLY after configuring the E1/T1 settings according to the specifi-
cations of your PSTN provider (see
Appendix: Pin Assignment of E1/T1
).
•
Connect the Ethernet port on your PC via a straight CAT 5 cable with an RJ-45 connec-
tor to the LAN socket of the QuadroE1/T1. If a hub or switch is connected between the
QuadroE1/T1 and your PC, use a crossover cable from the LAN interface of the
•
ct the WAN port of the QuadroE1/T1 to the Private Data Network or Internet ser-
•
ill glow for several minutes. As soon as Info is off, the QuadroE1/T1 is opera-
•
QuadroE1/T1 to the hub/switch.
Conne
vice.
•
When using a DSL or Cable modem, power up the modem before the Quadro.
Connect the power adapter to the POWER port on the QuadroE1/T1’s rear panel and
plug the power adapter into a power outlet. Only use the original power adapter and plug
it into a power strip with surge protection or to a UPS if available.
The red LED (Fault) will glow for several seconds followed by the yellow LED (Info),
which w
tional.
Power up any hub or switch followed by any PC and other devices on the LAN side.
Please Note:
The PC must be configured for DHCP to receive an IP address directly
from the QuadroE1/T1. Refer to
Appendix: PC DHCP Settings
for instructions on how to
set up a PC for DHCP operation.
Check the LEDs: The green Busy LED should glow continuously. The green LAN and
WAN LEDs will blink when cables are connected to these ports and all devices are pow-
•
ms, hubs, switches and routers will require the use of
crossover cables.
ered up. If the green LAN and WAN LEDs do not blink, verify cabling and ensure that all
devices are powered up.
Please Note
: CAT 5 cables can be faulty without visual indication. The LAN and WAN
LEDs verify that the Ethernet connection is established between the end points. If these
LEDs are not illuminated, there is a connection problem between the QuadroE1/T1 and
the other device. Some mode
Summary of Contents for QuadroE1/T1
Page 1: ......
