Page 6
7075-166C
May 23, 2013
R
VOYAGEUR GRAND Wood Insert
1
Listing and Code Approvals
The Quadra-Fire VOYAGEUR GRAND meets the U.S. Envi
-
ronmental Protection Agency’s 1990 particulate emission
standards.
A. Appliance Certification
C. Glass Specifications
D. BTU & Efficiency Specifications
This stove is equipped with 5mm ceramic glass. Replace
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
B. Mobile Home Approved
EPA Certified:
3.1 grams per hour
Efficiency:
80%
BTU Output:
10,700 to 28,500 per hr
Heating Capacity:
1,100 to 2,800 sq ft depend-
ing on climate zone
Vent Size:
6 inches
Firebox Size:
2.35 cubic feet
Max Wood Length:
21 inches
Fuel:
Cord Wood
Shipping Weight:
389 lbs
Model:
VOYAGEUR GRAND Wood Insert
Laboratory:
Intertek
Report No:
100868597PRT-001
Type:
Solid Fuel Type, Listed Room Heater
Standard:
UL1482 and ULC S628-93 and
(UM) 84-HUD, Mobile Home
Approved.
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products,
their specifications and/or price without notice.
NOTE: This installation must conform with local codes. In the
absence of local codes you must comply with the UL1482,
(UM) 84-HUD and NPFA211 in the U.S.A. and the ULC S628-
93 and CAN/CSA-B365 Installation Codes in Canada.
•
This appliance is approved for mobile home installa-
tions when not installed in a sleeping room and when
an outside combustion air inlet is provided.
•
The structural integrity of the mobile home floor, ceil
-
ing, and walls must be maintained.
•
The appliance must be properly grounded to the
frame of the mobile home with #8 copper ground
wire, and use only listed connector pipe.
•
Outside Air Kit, part OAK-ACC must be installed in a
mobile home installation.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified
installer, service agency or your dealer.
Quadra-Fire is a registered trademark of Hearth & Home
Technologies.
• Installation and use of any damaged appliance.
• Modification of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
• Operating appliance without fully assembling all
components.
• Operating appliance without legs attached (if supplied with
unit).
• Do NOT Overfire - If appliance or chimney connector glows,
you are overfiring.
Any such action that may cause a fire hazard.
WARNING
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
Intertek Testing Laboratory is a National Recognized
Test Lab (NRTL) approved by OSHA.
