Page 42
7075-166C
May 23, 2013
R
VOYAGEUR GRAND Wood Insert
1. Remove contents from box being careful not to scratch or
damage the cast trim pieces.
2
. Lay surround face down on a protected surface to prevent
scratching.
3. Using a 4 to 6 inches long Phillips head screw driver attach
the side surrounds to the top surround using (2) #8 sheet
metal screws on each side provided with the kit
4
. Place the peel and stick round felt vibration insulation pads
on the front side in each corner of the top metal piece and
on the back side in each corner of the top cast piece.
Figure
42.1.
5. Place the corresponding cast trim pieces (2 cast trim sides
and 1 cast trim header) underneath the panel set, also face
down. Align the holes in the metal pieces with the 5 bosses
on the top cast piece and 2 bosses on each side piece.
6. Secure the magnet to the bracket and attach the magnet and
bracket to each metal side piece at the bottom. The magnet
is facing the front.
Figure 42.2.
Included in Surround Kit:
(2) side pieces, left and right; (1)
l top piece; (1) fastener package.
Included in Cast Trim Kit:
(2) cast trim legs, left and right;
(1) cast trim header; (2) cast trim footers, left and right; (1)
fastener package.
Tools Needed:
Powered 4 to 6 inches long Phillips head
screw driver; pliers
G. Standard Surround & Cast Trim Kit
(4) Felt Vibration Insulation Pads
Secure
Surrounds to
Cast Trim Kit
Attach Magnet
before installing
Cast Footers
Magnet Installed
Cast Footers,
Left & Right
Figure 42.1
Back
of
Side
Piece
Magnet Attached - Faces Front
Clearance Notch
7. Place the cast footers under the metal sides aligning the top
and bottom holes in the cast footers and metal sides.
8. The 9 mounting clips are shipped in one long strip. Hand
break apart or use pliers.
9. Each clip has a clearance notch to allow room for the cast
on the insert. Place the clip so the notch is facing the outer
edges of the surrounds.
Figure 42.3.
10. It is best to install all of the 1/4-20 screws only half way at
first to allow for adjustments. After adjustment, tighten the
2 screws in each cast footer first and then work your way
around to the rest.
11. Slide surround and trim over the top of the insert into place
matching the mounting tabs on the metal sides with the slots
on the insert.
Figure 42.4
.
12
. Align the 2 screws in the top metal surround piece to the
2 alignment holes on the appliance top. Secure in place.
Figure 42.4.
Figure 42.2
Figure 42.3
Match Mounting
Tabs to Slots on
the appliance
Figure 42.4
Standard Size: 42-1/2 in. W x 30 in. H
Large Size: 48 in. W x 34 in. H
