Page 28
Quadra-Fire • Hudson Bay • 7003-121_R20 • 11/14
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
firebox.
B. Accessories
Install approved accessories per instructions included
with accessories. Refer to Section 12 for appropriate
accessories.
Shock or fire risk.
Use ONLY optional accessories approved for this
appliance.
• Using non-listed accessories voids warranty.
• Using non-listed accessories may result in a
safety hazard.
• Only Hearth & Home Technologies approved
accessories may be used safely.
C. Door Crown Installation
Figure 8.1
-
Open lower access panel. Pull out and unhook
the two spring latches on the bottom of the appliance that
secure the door.
Rotate the door forward approximately 1-1/2 in. (38mm).
Holding the ashlip, lift the door up off of the stationary
latches and away from the appliance.
Figure 8.2 -
Uninstall the existing crown by removing the four
screws on the back side of the door. Retain the screws.
Figure 8.3 -
Use a flat-head screwdriver to pry the black
crown free on the right side. Remove the crown and discard.
Figure 8.4 -
Carefully align the left side of the crown into
place, and wrap it across the face of door, finally
snapping
it into place on the right hand side. Reinsert and tighten the
screws previously removed.
Use a soft cloth and a window cleaning solution to clean
all fingerprint oils from the gold or nickel surface of crown
PRIOR
to lighting the appliance.
8
Appliance Set-Up
WARNING
!
Stationary latches
Spring latches
