27
February 19, 2020
7037-801B
F. Door Handle Assembly
43ST-ACC-C
1. Slide door handle shaft through hole on door
(Figure 27.2)
.
2. Add up to three 3/8 washers on the inside of the door.
Figure 27.2
Locknut
Latch Cam
3/8 inch
Spacing
Washers
Door Cross
Section
Square Key
Door Handle Shaft
Fiber Handle
Add up to 3
washers on
this side of
the door
NOTE:
The quantity of washers added will change how
the door seals. You many need to tear down
the handle assembly a few times to gain the
correct seal.
3. Add square key to door handle shaft; may need to use
a rubber mallet to ensure key sits firmly into groove of
door handle shaft.
4. Slide cast iron cam latch over door handle shaft and
locking key.
NOTE:
DO NOT over tighten locking nut; door handle
needs to move smoothly!
Figure 27.1
43M-ACC-C
Install spring handle using a counter-clockwise motion until
the spring handle has a 2 inch clearance from bend of door
hand rod
(Figure 27.1)
.
Door Handle
Spring
Handle
2 inch (51mm) clearance
required from bend in door
handle rod to end of spring
handle.
