Quadra-Fire 4300 Series, Installation Manual

Page: 22 / 36

22 February 19, 2020 7037-801B
Figure 22.3
Figure 22.4
Figure 22.2
Ped Kit and Ash Removal System (Cont’d)
Installing Ped Kit
1. Follow Begin installing the ARS System instructions
provided on page 21 .
2. Slide pedestal over adapter on bottom of
appliance and secure with bolts from heat shield
(Figure 23.1 on page 23 ) .
3. Install ARS Spacer on left hand side with one bolt using
Phillips head screwdriver (Figure 22.4) .
4. Carefully stand appliance up and place in
desired location.
Finishing the ARS Installation
1. Replace front bricks that were removed in step 1
of Begin installing the ARS System on page 21
(Figure 23.2 on page 23 ) .
2. Install the ash drawer to pedestal base.
3. Install ARS access cover inside of ARS Channel that is
located inside the firebox (Figure 23.2 on page 23 ) .
Ash Removal
Spacer
Insert two bolts through ARS
Channel, Appliance, Gasket, and
ARS Door Assembly; secure with
two nuts.
Figure 22.1
NOTE: If installing a floor installation of an outside
air kit on a Step Top model with a pedestal
assembly you must attach the enclosed
cover plate with 4 screws to the back of the
appliance. Other wise you may discard this piece
(Figure 23.3 on page 23 ) .
CHECK BAFFLE BOARDS & CERAMIC BLANKET!
• Verify that the baffle boards and ceramic blanket are
in their proper locations.
• It is important that the baffle boards and ceramic
blanket are correctly installed for proper burn safety.
CAUTION
Ash Door Rod shown
in installed position
Door latch with the
ash door rod locked
in place
Knob